Pin Security Code

It is important to set a security pin for your lawn care device. This will ensure that no one but you can access the device and use it. Here are instructions on how to set your pin: 

For MowRo's purchased in 2022 onwards:

1. Start by pressing the factory code 0000 + "START."
2. MowRo leaves the docking station and starts running.
3. After a few feet press "STOP" - error code E1 will appear on the display.
4. Press and hold "START" for 10 seconds until code U*** appears on the display.
5. Press "SET" and the lock icon flashes. Enter the factory code 0000 by pressing "OK" after each number. You should now see 0000 constantly lit on the screen with no flashing.
6. Press "SET" again and the lock icon flashes.
7. Now enter your personally chosen 4-digit security code by pressing "OK" after each number.
8. Your personal security code is now constantly lit on the screen with no flashing.
9. Finally, Press START and the machine continues to run.
10. REMEMBER YOUR CODE!

For MowRo's purchased prior to 2022:

1. Unlock the mower. (If locked, see steps 1-7 in the Unlocking the Mower section.)
2. Press the “Set” button until the lock icon shows on the top of the LCD screen.
3. Upon reaching the lock icon, your screen will display four zeros, with the first zero blinking.
4. From this screen, you can switch between the zeros by pressing the “OK” button.
5. To set your PIN, shift to the desired zero and use the up and down arrows located on the “Home” and “Start” buttons to set the number.
6. Repeat steps four and five for all remaining numbers.
7. Once you have entered your desired PIN, press the “OK” button to toggle through all the numbers until none of them are blinking.
8. Press “Set” to save your PIN. The lock icon should now be gone from the top of the screen. 
9. REMEMBER YOUR CODE!

By following these steps, you can ensure that your lawn care device is secure and only accessible by you.